The mold has been parted and the runner can be clearly seen. The runner is the long trough at near the top of the mold and permits the molten metal to run from the sprue to the farther cavity. In plastics molding this would be called the cavity side of the mold. Not sure if the term is the same in sand molding.
Previous Picture
21
of 52 
Next Picture
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
16 17 18 19 20 21 22 23 24 25 26 26A 26B
27 28 29 30 31 32 33 34 35 36 37 38 39 40 41
42 43 44 45 46 47 48 49 50 51 52
Return to First Page of This Set